EPiC – Epoxy Etch Primer

Premium Quality Single Pack Primer

Nutech EPiC Epoxy Etch Primer is a Premium quality Single Pack Coating developed by using the latest technology. Being a Single Pack Coating it is easy to use and is fast drying. It provides excellent adhesion to all common metals.

Suitable Substrates

  • Stainless Steel
  • Blasted Steel
  • Mild Steel
  • Aluminium
  • Galvanised Iron
  • Zincalume


Nutech Single Pack EPiC Epoxy Etch Primer has excellent adhesion properties to all the surfaces it’s applied. The EPiC Epoxy Base Resin provides excellent protection against corrosion and can be top coated within the same day.

Surface Preparation

All surfaces must be free from Rust, Oil, Grease, and all other surface contamination.


Brush, Roller, Spray – Stir thoroughly

Equipment Type

Good quality brush and a good solvent resistant roller sleeve. Spray application will depend on the type of finish required.


For spraying pressures and tip sizes, applicators should source this relevant information from their spray gun suppliers.


Brush, Roller



10% – EPiC Epoxy Thinners

Number of Coats

Brush, Roller

1 Even full coat


2 full passes or a minimum of 125 microns wet film thickness.

Dry and Re-Coat Times

Touch Dry

10 mins @ 25° C

Dry to Handle

30 minutes


After 1 hour @ 25° C.

Hard Cure

7 days

Clean Up

Nutech Epoxy Thinners


8 m2 per litre, for 15 microns dry

Other Information

Surface Temperatures

Above 10°C and below 30°C

Safety Precautions

  • Wear suitable protective clothing, gloves and a recommended respirator for spray application.
  • Make sure there is good air flow and ventilation before applying this coating.

Refer to Material Safety Data Sheet for additional safety and user information.

Important Note

The information given in this data sheet is based on many years experience and is correct to the best of our knowledge. However as the use of our product is beyond our control we can only be responsible for the quality of our product at the time of dispatch. For additional information about specifications or application please contact our company. As this information is of a general nature we cannot assume responsibility for individual use.