Nu-Flex
Description:
 

NuFlex is larger particle size, wet adhesion promoted acrylic emulsion coating for masonry surfaces and roof tiles. Its technically advanced formula and 100% acrylic resin guarantee extended durability and performance under the most adverse weather conditions. NuFlex is available in over 36 standard colours and can be custom tinted. The coating is non-yellowing and will provide a waterproof, non-fading, protective coating for a minimum of seven years with correct application and prepartion.

  
  Typical Properties:
  Appearance: Opaque white or coloured viscous liquid
  Total Solids: 38%
  pH: 9.0
  Specific Gravity: 1.01
  Water Solubility Soluble
  Min Film Forming Temp: 12 Degrees celsius
  Min Film Thickness: 190 microns (1 coat)
  Application Rate:

 

2 coats @ 4m2 per litre

 
  Applications:

NuFlex is a high quality semi-gloss exterior acrylic emulsion coating for roof tiles, concrete & masonry surfaces, metal and asbestos sheet roofing, and exhibits exceptional gloss, flow, and wet adhesion characteristics.

Two coats of NuFlex are recommended on surfaces primed/sealed with Nu-Prime, Master, or GP Primer for maximum durability.

Features:

NuFlex has been designed to provide a waterbased roof tile and concrete & masonry surface coating with excellent weatherproofing and durability, and exceptional wet adhesion performance.

Surfaces coated with NuFlex perform exceptionally under conditions of hot, cold, or wet weather, provided correct surface preparation has been ensured.

NuFlex provides excellent protection againstbacteria and mould.
  Benefits:
 
  • Guaranteed Intercoat Adhesion
  • Excellent Gloss And Colour Retention
  • Improved Mould, Fungus, and Lichen Resistance
  • 100% Weatherproof Guaranteed
  • Hardness And Flexibility
  • Faster Drying Time
  • Easy Application by Brush, Roller, Or Spray Unit
  • Ultra-Violet Radiation Resistant
  • Suitable for Smooth Or Porous Rough Tile Surfaces
  • Wide Range Of Standard And Custom Colours Available
  Warnings:
 
  • DO NOT apply NuFlex in very low temperatures to avoid adhesion problems.
  • DO NOT overcoat the prime/seal or base coat until each is completely dry.
  • Coating in very hot conditions will reduce gloss and may affect adhesion.
  Important Note:
  The information given in this data sheet is based on many years experience and is correct to the best of our knowledge. However as the use of our product is beyond our control we can only be responsible for the quality of our product at the time of dispatch. For additional information about specifications or application please contact our company. As this information is of a general nature we cannot assume responsibility for individual case.