Metalics
Description:
 

Nutech Metallic coating is manufactured from a lager partical size, wet adhesion promoted acrylic polymer and light stable metallic pigments. Its technically advanced formula and 100% acrylic resin guarantee maximum durability, performance, and insulation value under all weather conditions. Metallic are available in silver and five other modern designer colours. (Plum, Emerald, Willow, Copper, and Gunmetal) The coating is non-yellowing and will provide a waterproof, non-colour fading protective coating with correct application and surface preparation.

  
  Typical Properties:
  Appearance: Metallic coloured viscous liquid
  Total Solids: 40%
  pH: 9.0
  Specific Gravity: 1.01
  Water Solubility Soluble
  Min Film Forming Temp: 12 Degrees celsius
  Min Film Thickness: 190 microns (1 coat)
  Application Rate:

 

2 coats @ 4 m2 per litre

  Applications:
 

Metalics is a high quality gloss exterior acrylic emulsion coating for roof tiles, concrete & masonry surfaces, metal and asbestos sheet roofing, and exhibits exceptional gloss, flow, and wet adhesion characteristics.

two coats of metalics is recommended on surfaces primed/sealed with Nu-Primer, Master, or GP Primer for maximum durability.

Features:

Metalics has been designed to provide a waterbased alternative to alkyd enamels and solvent coating systems used for roof structures.

Metalics combine the ease and environmental advantages of using a waterbased coating system with the remarkable performance of 100% acrylic coating technology developed by Nutech over 30 years.
 

The high reflective properties of the metallic pigments in Metalic guarantee very good insulative properties of the coating compared to conventional paint and membrane systems.

Metalics provides excellent protection against bacteria and mould.
  Benefits:
 
  • Improved Drying Speed
  • Guaranteed Intercoat Adhesion
  • High Resistance To Mould And Fungus
  • 100% Water And Weatherproof Performance
  • Easy Application By Brush, Roller, Or Spray Unit
  • High Reflective Value To Maximise Insulation
  • Colour-Stable, Non-Yellowing Metallic Pigments
  • Hardness And Flexibility
  Warnings:
 
  • DO NOT apply Metalics in very low temeratures to avoid adhesion problems.
  • DO NOT overcoat the prime/seal or base coat until each is completely dry.
  • Coating in very hot conditions will reduce gloss and may affect adhesion.
  Important Note:
  The information given in this data sheet is based on many years experience and is correct to the best of our knowledge. However as the use of our product is beyond our control we can only be responsible for the quality of our product at the time of dispatch. For additional information about specifications or application please contact our company. As this information is of a general nature we cannot assume responsibility for individual case.