Nu EcoSafe – Rust Converter & Inhibitor

Water Based Rust Removing Compound

Nu EcoSafe Strip Rust Converter & Inhibitor is a water based rust removing compounds specifically designed to provide a clean, rust free surface prior to recoating. Nu EcoSafe Strip Rust Converter & Inhibitor can remove heavy rust and prevent re-rusting for extended periods of time.

Nu EcoSafe Strip Rust Converter Features

  • Water based
  • Fully biodegradable
  • Non flammable
  • Contains no TAPs or HAPs (Toxic/Hazardous Air Pollutants)
  • Easy clean up with running water
  • Low VOCs
  • Non ozone depleting
  • As quick as conventional products
  • Not regulated by authorities for storage
  • Mild odour
  • No corrosive fumes

Cost effective because

  • Reduces man hours and effort required to complete a project recoating.

Features

Nu EcoSafe Strip Rust Converter & Inhibitor has proven they will effectively remove all types of rust, whether light surface rust or deep seated blooms.

The end results produced with Nu EcoSafe Strip Rust Converter & Inhibitor are the same as those achieved by the harsh and dangerous chemicals presently used by industry.

The residue is easily removed by water rinsing and the surface is ready for a new coating.

New coatings exhibited no reduction of adhesion under standard adhesion pull tests.

If allowed to air dry, the product will protect the surface from re-rusting for extended periods of time.

Applications & Features

Equipment & Tools

Brush, Roller or Rag.

A brush or a roller for application over small areas.

A small hand pump, weed sprayer or conventional spray equipment capable of producing a fine atomized spray for larger areas.

Preparation

  • Ensure that all areas not to be cleaned are suitably protected.
  • The product should not be diluted and does not need any mixing before application.
  • The surface may be washed and cleaned prior to application however the surface should be dry prior to application of Nu EcoSafe Strip Rust Converter.
  • For extremely rusty surfaces it is necessary to wire brush the surface prior to treatment.

Dwell Time

The time required to remove the rust depends on the type of rust and depth of penetration.

  • Most rust will be cleaned within 10 to 15 minutes.
  • For extremely rusty surfaces it is also effective to place a rag on the surface and saturate with the rust converter, check surface at 30 minute intervals to ensure rust has been converted.

Coverage

Depending on the substrate, the coverage rate for Nu EcoSafe Strip Rust Converter normally falls between 8 to 10 sq. m. per Litre

Re-Coating

Nu EcoSafe Strip Rust Converter & Inhibitor will inhibit rust of approximately 3 months therefore recoating is recommended as rust may reoccur.

Safety Precautions

Proper safety procedures should be followed at all times while handling the product.

Refer to the Material Safety Data Sheet for important health and safety information before use.

Important Note

The information given in this data sheet is based on many years experience and is correct to the best of our knowledge. However as the use of our product is beyond our control we can only be responsible for the quality of our product at the time of dispatch. For additional information about specifications or application please contact our company. As this information is of a general nature we cannot assume responsibility for individual use.