EPiC – Industrial Enamel

High Gloss Enamel Surface Coating

Nutech Industrial Enamel is a modified single pack urethane enamel made in a high gloss finish. It can be applied to a variety of surfaces including Concrete, Timber and Metal Surfaces that have been primed with a suitable Metal Primer.

Features

Nutech Industrial Enamel has excellent durability for a single pack coating. It has very good corrosive and abrasive properties. It is hard wearing when cured and has excellent Gloss and Colour retention.

Suitable Substrates

  • Concrete
  • Stainless Steel
  • Blasted Steel
  • Mild Steel
  • Aluminium
  • Galvanused Iron
  • Timber

Surface Preparation

All surfaces must be free from Rust, Oil, Grease, and all other surface contamination. Bare concrete should be acid etched to increase surface porosity.

Application

Brush, roller, spray – Stir thoroughly.

Equipment Type

Good quality brush and a good quality solvent resistant sleeve. Spray application will depend on the type of finish required.

Thinning

Brush, Roller

Nil

Spray

10% - 15% Nutech Mineral Turps

Bare Concrete 1st coat only

20% - 25% Nutech Mineral Turps for surface penetration

Number of Coats

Brush, Roller

2 Coats

Spray

2-3 coats or a minimum of 65 microns wet film thickness

Dry and Re-Coat Times

Touch Dry

25mins @ 25° C

Re-Coat

Within 4 hours or After 24 hours @ 25° C

Hard Cure

7 days

Clean Up

Nutech Mineral Turps

Coverage

15 m2 per litre – on steel/smooth surfaces

8 – 10 m2 – on concrete/porous surfaces

Other Information

Surface Temperatures

Above 10 °C and below 30°C

Safety Precautions

  • Wear suitable protective clothing, gloves and a recommended respirator for spray application.
  • Make sure there is good air flow and ventilation before applying this coating.

Refer to Material Safety Data Sheet for additional safety and user information.

Important Note

The information given in this data sheet is based on many years experience and is correct to the best of our knowledge. However as the use of our product is beyond our control we can only be responsible for the quality of our product at the time of dispatch. For additional information about specifications or application please contact our company. As this information is of a general nature we cannot assume responsibility for individual use.